锆改性纳米TiO2的光催化性能研究

用溶胶-凝胶法制备了锆改性纳米二氧化钛光催化剂,并用XRD、UV-vis、BET等测定技术对所制得的粉体试样进行了表征.同时以甲基橙及苯酚为模拟污染物,评价了改性后纳米二氧化钛的光催化性能,发现其光催化活性大大高于未改性二氧化钛粉体,并得出当n(Zr)/n(Ti)=5/300时,锆改性纳米二氧化钛样品的光催化活性最高.     

玻璃纸生产废气中CS2和H2S的治理

阐述了玻璃纸生产中CS2和H2S废气产生的原理，介绍了该废气处理的现状，总结了目前普遍采用的冷凝法、活性炭吸附法、活性碳纤维吸附法、改性活性炭吸附法、螯合铁氧化法、吸收-吸附法等处理方法的特点和效果。介绍了一种先采用螯合铁氧化法、再采用冷凝法、最后采用活性炭吸附法的综合处理工艺，可使废气达标排放。     

A Two-Stage Particle Swarm Optimization Algorithm for MPPT of Partially Shaded PV Arrays

The power-voltage (P-V) characteristic curves of a PV array are nonlinear and have multiple peaks under partially shaded conditions (PSCs). This paper proposes a novel maximum power point tracking (MPPT) method for a PV system with reduced steady-state oscillation based on a two-stage particle swarm optimization (PSO) algorithm. The grouping method of the shuffled frog leaping algorithm (SFLA) is incorporated in the basic PSO algorithm (PSO-SFLA), ensuring fast and accurate searching of the global extremum. An adaptive speed factor is also introduced into the improved PSO to further enhance its convergence speed. Test results show that the proposed method converges in less than half the time taken by the conventional PSO method, and the power is improved by 33% under the worst PSCs, which confirms the superiority of the proposed method over the standard PSO algorithm in terms of tracking speed and steady-state oscillations under different PSCs.     

As（V）在金红石TiO2颗粒表面吸附特性及机理

通过静态动力学和热力学吸附实验，研究了温度、共存离子以及溶质的初始浓度对As（V）在金红石TiO2颗粒表面吸附的影响，探讨了As（V）在金红石TiO2颗粒表面吸附特性及机理。结果表明，在As（V）初始浓度为10mg／L，pH为7的条件下，25℃时的吸附量0．41mg／g高于30℃时的吸附量0．31mg／g，As（V）在金红石TiO，上的吸附为放热过程。CaCl2和MgCl2的添加对As（V）在金红石TiO2表面吸附起到明显的促进作用。T=25℃，Ca2＋或Mg2＋浓度为10mmol／L时，As（V）吸附量分别为0．64和0．56mg／g，Ca2＋比Mg2＋对As（V）吸附促进作用强。As（V）在金红石TiO2的吸附等温线符合Frendlich方程，Lagergren二级动力学方程能较好地描述As（V）在金红石TiO2颗粒表面吸附的动力学过程。     

气升回流一体化工艺处理生活污水简

针对分散型生活污水处理开发了气升回流一体化工艺，以校园生活污水为对象，研究其对生活污水中污染物的去除效果。该系统由好氧区、厌氧区、沉淀区和气升室组成，以曝气的剩余气体的气升作用实现混合液的回流，节省动力消耗。结果表明，本工艺对COD、氨氮及悬浮物（SS）有较好的去除效果，去除率分别达到80%、90%和75%左右，出水COD、NH₄⁺-N及SS平均浓度在40 mg/L、6.5 mg/L和10 mg/L左右。当进水COD在100~1 000 mg/L之间波动时，出水水质稳定。该工艺有较强的抗冲击负荷能力，且可实现剩余污泥的自消解。本工艺具有结构紧凑、占地少，运行费用低，维护简单的特点。     

一种基于蚯蚓学习行为的神经毒性实验方法研究

土壤生物的学习行为是一种综合性的神经高级活动,对土壤中的神经毒性污染物生态风险监测具有重要价值.本研究设计了一套试验装置,基于蚯蚓对白光刺激的厌恶本性,通过振动-白光配对刺激,对蚯蚓进行学习训练,使蚯蚓领会借助加速移动阻止白光刺激的策略,通过蚯蚓到达移动位移阈值的时间测定,对蚯蚓的学习行为进行测试,建立了蚯蚓的学习行为测试方法.采用建立的测试方法,对土壤中东莨菪碱和毒死蜱诱导下蚯蚓的学习行为进行了测试,结果表明,1～3 mg·kg-1东莨菪碱与4～12 mg·kg-1毒死蜱污染处理均对蚯蚓的学习能力造成了损伤,污染浓度越高,蚯蚓的学习能力损伤越严重.该测试方法可以快速有效地检测土壤污染导致的蚯蚓学习行为变化,有望用于低浓度神经毒性农药污染土壤的神经毒性快速诊断.     

Direct N2O decomposition over La2NiO4-based perovskite-type oxides

Direct decomposition of N₂O by perovskite-structure catalysts including La₂NiO₄, LaSrNiO₄, and La_0.7Ce_0.3SrNiO₄ was investigated. The catalysts were prepared by the Pechini method and characterized by x-ray diffraction (XRD), BET, scanning electron microscopy (SEM), and O₂-TPD. Experimental results indicate that the properties of La₂NiO₄ are significantly improved by partially substituting La with Sr and Ce. N₂O decomposition efficiencies achieved with LaSrNiO₄ and La_0.7Ce_0.3SrNiO₄ are 44 and 36%, respectively, at 400ºC. As the temperature was increased to 600ºC, N₂O decomposition efficiency achieved with LaSrNiO₄ and La_0.7Ce_0.3SrNiO₄ reached 100% at an inlet N₂O concentration of 1,000 ppm, while the space velocity was fixed at 8,000 hr^?1. In addition, effects of various parameters including oxygen, water vapor, and space velocity were also explored. The results indicate that N₂O decomposition efficiencies achieved with LaSrNiO₄ and La_0.7Ce_0.3SrNiO₄ are not significantly affected as space velocity is increased from 8,000 to 20,000 hr^?1, while La_0.7Ce_0.3SrNiO₄ shows better tolerance for O₂ and H₂O_(g). On the other hand, N₂ yield with LaSrNiO₄ as catalyst can be significantly improved by doping Ce. At a gas hour space velocity of 8,000 hr^?1, and a temperature of 600ºC, high N₂O decomposition efficiency and N₂ yield were maintained throughout the durability test of 60 hr, indicating the long-term stability of La_0.7Ce_0.3SrNiO₄ for N₂O decomposition.

Implications:Nitrous oxide (N₂O) not only has a high global warming potential (GWP₁₀₀ = 310), but also potentially destroys ozone in the stratosphere. Pervoskite-type catalysts including La₂NiO₄, LaSrNiO₄, and La_0.7Ce_0.3SrNiO₄ are applied for direct N₂O decomposition. The results show that N₂O decomposition can be enhanced as Sr and Ce are doped into La₂NiO₄. At 600ºC, N₂O decomposition efficiencies achieved with LaSrNiO₄ and La_0.7Ce_0.3SrNiO₄ reach 100%, demonstrating high activity and good potential for direct N₂O decomposition. Effects of O₂ and H₂O_(g) contents on catalytic activities are also evaluated and discussed.     

Stand-alone wind power system with battery/supercapacitor hybrid energy storage

This paper presents a stand-alone wind power system with battery/supercapacitor hybrid energy storage. A stand-alone wind power system mainly consists of a wind turbine, a permanent magnet synchronous generator, hybrid energy storage devices based on a vanadium redox flow battery and a supercapacitor, an AC/DC converter, two bidirectional DC/DC converters, a DC/AC converter and a variable load. Several control strategies for the stand-alone wind power system are involved such as a maximum power point tracking (MPPT) control, a vanadium redox flow battery charge/discharge control and a supercapacitor charge/discharge control. The proposed MPPT control combines a sliding mode control with an extreme search control to capture maximum wind energy. This strategy avoids the necessity of measuring wind velocity, obtaining models or parameters of the wind turbine and calculating the differentials of the power generated from the wind power system and from the speed of the generator. The battery charge/discharge control maintains a constant DC bus voltage. When the battery charging/discharging current reaches the setting threshold, the charge/discharge control of the supercapacitor is triggered to limit the charging/discharging current of the battery. The simulation results show that the proposed method can rapidly respond to variations in wind velocity and load power.